Controller , Inverter
(Suggested batteries and it’s capacity)
can supply power for
FD5.0-3KW OFF-grid Electric system sketch
● Material: FRP (Fiber glass reinforced*3)
● Diameter of wind wheel: 5.0M
● Rated speed (rpm): 220
● Rated wind speed:10M/S
● Starte up wind speed: 3 M/S
● Net weight:42KGS
Hub and press board
● Type of generator: Permanent-magnet 3-phase A.C.
● Stator: Silicon steel sheet
● Magnet steel: NdFeB
● Wire package: Copper wire
● Net weight: 100KG
Packing size: 80cm*60m*60cm
● Wind turbine power:3kw.
● wind turbine rated voltage:AC216 V
● wind turbine rated current:AC13A
● wind turbine rated charge current:DC13A
● Net weight:8 KGS
● Diverter:if the generator produces more electricity,it will heat the electric fumace heating wire and thus protect the battery
Inverter Technical Parameter
3-1、Please check the aspect of the inverter after open the box. If the inverter has been destroyed, please don’t use it.
3-2、Please read the specification before use the inverter.
3-3、 Please ensure that the switch is turned off before connect the wires.
3-4、The red terminal is positive pole ,connect the battery’s positive pole; the black terminal is negative pole, connect the battery’s negative pole.
3-5、The inverter can be used in the system after turn on the switch.
3-6、The wire between inverter and battery is as short as possible .Make sure that the inverter is dry and drawing.
4、Matters needing attention
7-1、The inverter has earthing terminal. Please connect it to earth wire when it is operating, preventing faradism from injuring human.
7-2、Don’t reverse all the terminals。
7-3、Don’t take apart the inverter ,there is high voltage in it.
6-1. Install the damping package;
6-2. Turn the inverter 90 degree;
6-3. Put the inverter into the external package;
6-4. Glue the box with the tape.